Reports of Sandisk cards causing RED X when more than one used in the iFlash-Quad. The advantage is that you have a really portable diyMod iPod that can. MicroSD (SDXC) cards reported by iFlash users : Manufacturer / Brand The iFlash adapter is the solution to performing the audiophile hardware hack. Be wary of cheap, high capacity cards – If it looks too good to be true – then it is fake! We always suggest testing the SD card fully using something like H2Testw.įullsize SD (SDXC) cards reported by iFlash users : Manufacturer / Brand Transparent film is still on the screen to avoid getting scratches or fingerprints while in. A new 2000 mAh battery was installed and you get a fresh new green and black aluminum case.
Custom iPod Classic 7th gen 160 GB that was upgraded with an iFlash solo board and a 256 gb sandisk micro SD card. Tip: MicroSD market is full of fake and mislabelled cards – try to purchase cards which the seller has obtained directly from the manufacturer.
Apple iPod classic 7th Generation Green Black 256GB iFlash SSD, 2000mAh Battery.
We suggest buying the fastest card in your budget as they tend to have faster access times and better quality memory chips. User Reported working SD cards (updated: 5th January 2022)Īll modern UHS-I U1 and U3 cards will generally work ok. IPod is now ready to restore & sync using iTunes.
Slide battery cable in to the connector and push down the black latch to lock the ribbon in place. Installation is complete, ready for the iPod to be closed. Use two pads if fitting in to a thick caseback.
IFLASH IPOD INSTALL
Install iFlash-Solo in to the iPod, make sure the ribbon is fully home, then lock the black bar down.Īttach Foam Pad(s) on top of the SD connector, overlap on to the SD card – this will secure the SD card from releasing from the iFlash-Solo.
IFLASH IPOD HOW TO
Make sure the black bar has been raised on the Zif connector. How to dissemble a Ipod Classic 6th Gen and replace the screen, housing and click wheel as well as installing a iFlash card for Micro SD Card support instead. Insert and lock the SD card in to the iFlash-Solo. iPod is ready to accept the iFlash board. Remove all rubber bumpers and strips from the iPods if any remain after the HDD is removed. Gently lift the black bar to release the ribbon from the HDD. Rest the front and back side by side, be careful to not cause too much stress on the headphone ribbon. I suggest watching some iPod opening videos on the internet.īefore pulling the case apart, release the battery cable – lift the black lock bar -or- gently using even pressure pull up the battery ribbon away from the connector. Using suitable tools, release the holding clips, making your way around the case till it opens.
0 kommentar(er)
